According to the standard BS-3144,JIB-K6545 Leather Bally Flexing Tester HZ-3001

 Leather Bally Flexing tester is used to test the folding nature for various leather and fabric. The machine used to test the folding nature for various leather and fabric, Materials need be nipped both inside and outside, Twist and turn over and over again until a certain number, Observe the damage of the tested materials, this machine applied to use in clothing, shoes, bags and other thin material leather.

Equipment Summary
Leather Bally Flexing tester is used to test the folding nature for various leather and fabric.The machine used to test the folding nature for various leather and fabric, Materials need be nipped both inside and outside, Twist and turn over and over again until a certain number, Observe the damage of the tested materials, this machine applied to use in clothing, shoes, bags and other thin material leather.

Corresponding Standard
According to the standard BS-3144,JIB-K6545

Applicable Industry
Used to test leather performance in shoes, clothing, luggage handbag industry, research laboratories; commodity inspection, arbitration and technical supervision departments.

Technical Parameters

Machine Structure

Specimen Installation Method

• The specimen surface folded inward, its one end fixed on the upper fixture
• Jig into upper levels (start inching switch adjustment knob, turned on the fixture of the axis of rotation Angle curve ring indicator at 0 score).
• Specimens with another free side as the outer surface of specimens reverse folded stretch not slack, and fixed clamping on the lower fixture.

Operation Procedure

• According to CNS 1272 to make the sample
• Turn on the power and check the machine if can be run normally.
• Turn on the Reverse angle,make the upper grip adjust to carved ring level
• Install the specimen.
• Set the test times on counter
• Run the test

Notice

• Specimen clamping with tight not slip for the principle of not holding tight fixture screw teeth or jaw damage
• Specimens shall be used for clamping with handle, so as not to damage the teeth
• Startup operation, must be left hand area, can according to rev. Switch on the dashboard, so as not to cause harm
• Specimen of clamping, the fixture must be in a horizontal position, before clamping can operate the machine otherwise and specimen
• Test process if there is often happens, should stop the machine immediately to check out, in order to avoid machine damage
• The parts of the control panel and close switch should be protected from damp and rules
• Professional operate this machine

Maintenance and Maintain

• Must turn off the power after the test
• Keep the machine clearance
• Motion link must be oiled per month
•  

Lixian Instrument owned CE/ISO/ASTM/ROSH/UL certification, and have exported to more than 70 countries like the USA, Germany,South Korea, Greece, India, Singapore, Brazil, Iraq, Saudi Arabia and so on. Lixian Instrument have a professional R & D team and a reliable quality management system, which introduced the CNC processing center and CNC lathe and other advanced equipment in 2010, successfully obtained the CMC measurement certificate and passed ISO 9001 system authentication.